Shut off the gas shut-off valve in the gas supply line to. Remove the control knob and the chassis manifold. Remove 2 screws from the Bracket-Latch sub to the. Remove the latch-rod from the Assy bracket-latch front. Remove 2 screws holding the Assy bracket-latch front.
Remove cooktop as described above. Carefully remove electrode locking clips from the bottom. Disconnect the wires at the connectors. Connect the new ignition switch harness to the wire. Open the oven door and remove the oven racks. Disconnect connector of the sensor thermister to the. Turn off the electrical supply going to the range. Disconnect the connector of HSI of the burner bake. Open the oven door and remove the racks D. Remove cover-back main wire to the rear of the oven.
Disconnect the wires or the connector of the HSI. Remove 1 screw of bracket HSI-wire and remove 4. Carefully remove Assy-burner broil spreader. Reverse the order to install a new bake burner. Remove the oven burner closest to the faulty ignitor. Ins tallation ins. Connect flexible metal appliance connector to the adapter on the range.
When all connections have been made, make sure all range controls are in the. Use a liquid leak detector at all joints and connections to check for leaks in the system. Flexible connector hookup Installer: Inform the consumer of the location of the gas shut-off valve. Gas Flo. If your area requires a rigid pipe hookup, contact a qualified installer, service agency, or gas supplier. Cold or room-temperature foods cannot be heated, warmed, or cooked in the warming drawer.
Do not locate the range where it may be subject to strong drafts. Provide adequate clearances between the range and adjacent combustible surfaces. Page Minimum Dimensions minimum dimensions If overhead cabinets are provided, a range hood should also be provided that projects horizontally a minimum of 5 in The counter top around the cut-out should be flat and leveled see hatched area on Fig. Page 22 gAS ReQuiRemeNtS provide adequate gas supply This range is designed to operate at a pressure of 5 in 13 cm of water column on natural gas or 10 in 25 cm of water column on Lp gas propane or butane.
Make sure you are supplying your range with the type of gas for which it is designed. Page 25 usage situations where appliance power cord will be disconnected frequently Do not use an adapter plug in these situations because disconnecting of the power cord places undue strain on the adapter and leads to eventual failure of the adapter ground terminal.
Where a standard two-prong wall receptacle is encountered, it is the personal responsibility and obligation of the customer to have it replaced with a three-prong grounding receptacle by a qualified electrician before using the appliance. Improper installation, adjustment, service, or maintenance can cause personal injury or property damage.
Page 28 If the information in this manual is not followed exactly, a fire or explosion may result, causing death, personal injury, or property damage. Page Flexible Connector Hookup All new gas ranges are shipped from the factory set up to use natural gas. Any Samsung gas range can be converted to use LP gas.
Refer to page 72 in the User Manual to contact a qualified service technician. Page 30 Step 4. Adds a filler strip to the rear of the range. Page 32 Step 7. Make sure the range is positioned where you want it. Using a wrench, level the range by turning the front leveling legs in or out as necessary. Counterclockwise shortens the leg and lowers the Leveling leg range.
Page 33 Step 8. Assemble the surface burners Do not operate the surface burners without all burner parts in place. Position surface burner heads on top of the surface burner manifolds as shown at right.
0コメント